HEART'S FLAMEoutdoor solid surface gas fire table
A 1.8 metre monolith for a terrace, patio or lounge area: an ultra-white solid surface body, a satin AISI 304 steel band around it and two weatherproof LED light lines low on the body that make the table appear to float. The fire line runs along the centre of the top, leaving a flat stone surface around it that takes glasses and tableware.
Unlike the bioethanol models in the range, this one is a table as well as a hearth: 500 mm high, the usual height of a coffee table, with a broad stone surface around the burner. Solid surface takes no water, grease or stains, is unaffected by frost and UV, and everyday scuffs come out with an abrasive sponge.
At 98 kilograms the table stays put on an exposed terrace — no fixing to the floor is needed. In winter a protective cover is recommended.
- 8–12 kW output. A linear AISI 304 stainless steel module, 800–850 mm fire line, smooth flame height control.
- Two gas types. LPG cylinder gas (28–30 / 37 mbar) or mains natural gas (20 mbar) — the gas train is universal.
- Spark ignition. Automatic, with three attempts and a cut-off if they fail.
- Remote, panel and timer. A wireless remote with 3–5 flame levels, a touch panel on the body, auto shut-off on a timer from 30 minutes to 8 hours, LED status and ignition error indication.
- 12 V power. A 220/12 V adapter plus a backup 4×AA battery compartment, so a power cut does not stop the fireplace.
At the maximum consumption of 0.55–0.80 kg/h a standard 27 litre cylinder lasts roughly 14–20 hours. That is calculated from the rated consumption rather than measured: the real figure depends on the flame level, wind and temperature.
- Gas control
- A thermoelectric sensor shuts off the gas in under a second if the flame is lost or blown out by wind
- Leak protection
- Double electromagnetic solenoid valve, tightness class A
- Thermal protection
- A thermal relay cuts the gas supply if the electronics compartment overheats above 70 °C
- ODS oxygen sensor
- Shuts the burner down if oxygen falls below 18.5 % — relevant when the table stands under a canopy or in an enclosed patio
- Wind screen
- 120 mm tempered Optiwhite glass stabilises the flame and shields the burning zone from accidental contact
- Emergency switch
- A mechanical master switch that fully de-energises the system
The cylinder lives inside the body: the side panel pulls out together with its shelf and opens a niche for a standard cylinder of up to 27 litres. No hose and no regulator are visible from outside — the monolith stays a table.
Nominal dimensions in millimetres, for free-standing installation.
- Cylinder compartment
- standard cylinder up to 27 l
- Net weight
- 98 kg, without cylinder
- Gross weight
- 121 kg
- Article
- ALB-FRP-HTF
- Product type
- Outdoor gas fire table, free-standing
- Body material
- Solid surface (acrylic artificial stone), ultra-white matt
- Decorative moulding
- Stainless steel AISI 304 band around the body, satin finish, with the ALBELA logo
- Wind screen
- Tempered low-iron Optiwhite glass, 120 mm high
- Dimensions (L × W × H)
- 1800 × 600 × 500 mm
- Stone body height
- 400 mm
- Light lines
- 100 mm, recessed
- Net weight
- 98 kg (without the gas cylinder)
- Gross weight
- 121 kg
- Burner type
- Linear automatic 1000 mm gas module, AISI 304 stainless steel body and tray
- Fire line length
- 800–850 mm
- Heat output
- 8–12 kW, smooth flame height control
- Gas type
- LPG cylinder gas (propane-butane, 28–30 / 37 mbar) or mains natural gas (methane, 20 mbar)
- Gas consumption (max)
- LPG 0.55–0.80 kg/h; NG 0.85–1.20 m³/h
- Runtime per cylinder
- About 14–20 hours on a 27 l cylinder (calculated from maximum consumption)
- Cylinder compartment
- Concealed internal niche with a pull-out service hatch, for a standard cylinder up to 27 l
- Delivery set
- Fire table, wind screen, connection fittings. The gas cylinder is not included
- Ignition
- Automatic spark ignition, three attempts with cut-off on failure
- Control
- Wireless remote (3–5 flame levels), touch panel on the body, timer from 30 minutes to 8 hours, LED status and error indication
- Electronics power supply
- 12 V DC (220/12 V adapter) plus a backup 4×AA battery compartment
- Gas control
- A thermoelectric sensor shuts off the gas supply in under a second if the flame is blown out
- Leak protection
- Double electromagnetic solenoid valve, tightness class A
- Thermal protection
- A thermal relay cuts the gas supply if the electronics compartment overheats above 70 °C
- ODS oxygen sensor
- Shuts the burner down if the O₂ concentration falls below 18.5 % — relevant under a canopy or in an enclosed patio
- Emergency switch
- A mechanical master switch that fully de-energises the system
- Light lines
- Concealed weatherproof linear LED module, IP65, warm 3000K light
- Installation
- Outdoors: terrace, patio, lounge area; under a canopy or in the open. No additional fixing required
- Care
- Year-round use; everyday scuffs are removed with an abrasive sponge; a protective cover is recommended for winter
- Availability
- Made to order
- Lead time
- 20 working days
- Warranty
- Burner module — 2 years; body — 2 years full, 8 years on structural integrity
- Production
- Body — Kirishi, Leningrad Region; burner module — OEM platform
Made to order, 20 working days. Leave a request and we will send a quote with the price, lead time and shipping terms.